Mitsubishi Q Series - Page 182

6 - 25 6 - 25
MELSEC-Q
6 PROGRAMMING
[Cascade control setting]
Cascade Bias............................................................"-500"
Cascade Gain ..........................................................."2000"
(b) Auto refresh setting (Refer to Section 5.5)
Error Code .................................................................."W500"
CH1 Measured Value (PV) ........................................"W501"
(c) Intelligent function module parameter write (Refer to Section 5.3.3)
The intelligent function module parameters are written to the remote I/O
station.
Perform this operation on the parameter setting unit selection screen on
intelligent function module.