Mitsubishi Q Series User Manual

7 - 12 7 - 12
MELSEC-Q
7 ONLINE MODULE CHANGE
(4) Operation check
(a) To make an operation check, click the [Cancel] button to cancel control
resumption.
(b) Click the [OK] button to leave the "Online module change" mode.
(c) Click the [Close] button to close the System monitor screen.
(d) Choose "Online" - "Debug" - "Device test" on GX Developer to set the
prerecorded values to the buffer memory.
(e) To back up the data on the FeRAM, turn the FeRAM backup command
(Yn8) from OFF to ON to write the buffer memory contents to the FeRAM.

Mitsubishi Q Series Specifications

General

I/O Points	Up to 4096 points
Communication	Ethernet, RS-232, RS-485
I/O Modules	Digital, Analog, Specialized
Programming Language	Function Block Diagram, Structured Text
Power Supply	24V DC, 100-240V AC
Operating Temperature	0°C to 55°C
Shock Resistance	147 m/s2 acceleration, 3 times in each of X, Y, and Z directions
Program Capacity	Up to 252K steps