Mobotix T26 - Page 4

44
Table of Contents
2.1.4 Recommendation for Cabling 60
2.1.5 Installation Tip: Replacing an Existing Doorbell by a T26 62
2.2 Remote Stations and Network Connection 64
2.2.1 Notes on Cable Lengths and Power Supply 64
2.2.2 Direct Connection of One Remote Station 64
2.2.3 Network Connection with Multiple Remote Stations 65
2.3 Mounting the Frame and Housing 68
2.3.1 Determining the Installation Position 68
2.3.2 Inserting the Cables 70
2.3.3 Attaching the Housing 72
2.3.4 Cabling in the On-Wall Housing 74
2.3.5 Mounting the Terminal Board and Fitting the Network Cable 76
2.3.6 Applying the Gasket 77
2.3.7 Attaching the Frame and Connecting the The Protection 78
2.3.8 Mechanical The-Protection Lock 80
2.4 Installing the T26 Modules 82
2.4.1 Installing the T26-CamCore Camera Module 82
2.4.2 Preparing the BellRFID Access Module 86
2.4.3 Installing the Access Module (KeypadRFID/BellRFID) 88
2.4.4 Installing the Info Module 92
2.4.5 Installing the Info Module Mx2wire+ 94
2.4.6 Labeling the Info Module 96
2.4.7 Removing, Exchanging and Modifying Modules 98
2.5 Installing the MX-DoorMaster 100
2.5.1 Overview of Connectors 100
2.5.2 Connection Diagrams for Door Opener Versions 102
2.5.3 Mounting Instructions 104
2.5.4 Installation Using Cavity or In-Wall Socket 107
2.6 Installing the Mx2wire+ Indoor Unit 110
2.6.1 Overview of Mx2wire+ Technology and Connectors 110
2.6.2 Mounting Instructions 112
2.6.3 Installation Using Cavity or In-Wall Socket 113
2.6.4 Installation With Surface-Mounted Socket 115
2.6.5 Function of Mx2wire+ Status LEDs 117
2.7 Connecting External Devices to the Door Station 118
2.7.1 Using the IO Module 118
2.7.2 Using the Signal Outputs of the Access Module (KeypadRFID/BellRFID) 122
2.8 Finishing the Installation 124
2.8.1 Checking the Wiring and Activating The Protection 124
2.8.2 Conguring the MX-DoorMaster 126