Mobotix T26 - 1.1.6 Info Module Mx2 wire+ (With Mx2 wire+ Indoor Unit)

34
T26 System Manual Part 1: System Overview
1.1.6 Info Module Mx2wire+ (With Mx2wire+ Indoor Unit)
The info module with Mx2wire+ technology, combined with a second Mx2wire+ unit to be
mounted inside the building, oers users not only the standard info module functions but
also the option to connect and supply power to the door station via two-wire cabling instead
of a network cable (see Section 1.1.6). Advantage: Simple and cost-eective installation
thanks to reuse of already existing two-wire cabling.
Info eld can be labeled
(behind cover)
LED orange (data)
LED green (power supply)
Sealing plug
Gasket
48 V DC (optional additional
power supply)
Ethernet (PoE injector)
99 mm/3.90 in
99 mm/3.90 in
Two-wire
connection
Back with housing cover removed
To activate the LED illumination of the
module, you need to cautiously remove
the small black jumper on the circuit
board (using tweezers or small pliers)
before mounting the module itself.
LED illumination
activated
LED illumination
deactivated
A PoE+ switch or an external
voltage connection (48-57 V
DC, 600 mA) can be used
The two status LEDs
(orange, green) are acti-
vated for test purposes
within the rst 15 minutes
aer the info module
has been powered up