Mobotix T26 - SAFETY WARNINGS; Notes on Installing; Electrical installation; Electrical surges

7
SAFETY WARNINGS
Notes on Installing:
• This product must not be used in locations exposed to the dangers of explosion.
• Make sure that you install this product as outlined in Chapter 2, «Installation» of the
corresponding manual. A faulty installation can damage the camera!
• When installing this product, make sure that you are only using genuine MOBOTIX
parts and MOBOTIX connection cables.
• Only install this product on suitable, solid materials that provide for a sturdy installa
-
tion of the xing elements used.
Electrical installation: Electrical systems and equipment may only be installed, modied
and maintained by a qualied electrician or under the direction and supervision of a qual
-
ied electrician in accordance with the applicable electrical guidelines. Make sure to prop-
erly set up all electrical connections.
Electrical surges: MOBOTIX cameras are protected against the eects of small electrical
surges by numerous measures. These measures, however, cannot prevent the camera from
being damaged when stronger electrical surges occur. Special care should be taken when
installing the camera outside of buildings to ensure proper protection against lightning,
since this also protects the building and the whole network infrastructure.
Max. power consumption of attached extension modules: The power consumption of all
attached
MxBus modules must not exceed 3 W . When attaching modules to the MxBus
connector
and the USB socket, the power consumption of all attached modules must
not exceed 4 W
, if the camera is powered by PoE class 3 . If PoE class 2 is used, the power
consumption of all attached modules must not exceed 1 W!
Risk of overheating when exposed to direct sunlight: When mounting a black, dark gray
or amber-colored T26 DoorStation in locations where the device is exposed to direct sunlight,
the housing temperature can exceed the maximum allowed temperature limit. This can
result in electronic failures and injuries especially when touching exterior metal parts. If the
intended use of the device is at an (unprotected) outdoor location, you should only install
white or silver-colored modules and frames. This product must not be installed within the
reach of persons without the dome.
Power o before opening the camera: Make sure the power supply to the camera is discon
-
nected before opening the camera housing (e.g., when inserting or exchanging lenses, lens
units and SD cards).
Network security: MOBOTIX products include all of the necessary conguration options for
operation in Ethernet networks in compliance with data protection laws. The operator is
responsible for the data protection concept across the entire system. The basic settings
required to prevent misuse can be congured in the soware and are password-protected.
This prevents unauthorized parties from accessing these settings.