• “Internet Gateway Device discovery and Control Client”.
• “UPnP User Interface”.
6. Reboot your system.
Once you have installed the UPnP software and you have rebooted (and your net-
work includes the IGD system), you should be able to see the IGD controlled device
on your network.
For example, from the Network Connections window you should see the Internet
Gateway Device:
RIP
RIP is an Internet protocol you can set up to share routing table information with
other routing devices on your LAN, at your ISP’s location, or on remote networks
connected to your network via the ADSL line.
Most small home or ofce networks do not need to use RIP; they have only one
Router,such as the ADSL Router, and one path to an ISP. In these cases, there is no
need to share routes, because all Internet data from the network is sent to the same
ISP gateway.
You may want to congure RIP if any of the following circumstances apply to your
network:
−Your home network setup includes an additional Router or RIP-enabled PC (other
than the ADSL Router). The ADSL Router and the Router will need to communicate
via RIP to share their routing tables.
To Next Page
Loading...
Need help?
General