Modecom MC-4220 - Internet Access

www.modecom.eu
48
802.11n WLAN ADSL2+ Router
Other pages such as WirelessBasicSettingspage and WirelessSecuritySetup
page will also be updated appropriately as described in previous sections. In this
case, AP is in un-congured state before the station initiates the WPS handshake.
According to the WPS spec, AP will create a wireless prole with WPA2-mixed mode
and a random-generated key upon successfully doing the WPS handshake. How-
ever, AP will use the original wireless prole and give it to the station if AP is already
in congured state. That means all settings of AP will not change. Hence, all WPS
related pages keep the same.
Internet Access
This chapter describes how to congure the way that your device connects to the
Internet. Your ISP determines what type of Internet access you should use and pro-
vides you with any information that you need in order to congure the Internet access
to your device.
Your device needs the following address information in order to access the Inter-
net:
ATM PVC
To congure ATM PVC, enter the VPI and VCI provided by
ISP. Select the Service Type Index, Service Category and
enter the following information:
Peak Cell Rate•
Sustainable Cell Rate•
Maximum Burst Size•
Connection Type
To congure the connection type, select the protocol and
encapsulation type as indicated by ISP. Supported Protocol
types are:
RFC1483 Bridged•
RFC1483 MER•
PPPoE•
PPPoA•
RFC1483 Routed•
Supported Encapsulation types are:•
VCMUX•
LLC/SNAP•
WAN IP Settings
To congure WAN IP settings, enter the information as indi-
cated by ISP. Enable/Disable the Access Concentrator option.
Either enter the WAN IP or select the option to automatically
obtain IP address.
Check as applicable the following two options:
Enable NAT•
Add default Route•