EasyManuals Logo

Modecom MC-4220 User Manual

Modecom MC-4220
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #49 background imageLoading...
Page #49 background image
49
802.11n WLAN ADSL2+ Router
Broadband User-
name and Pass-
word
To congure Broadband Username and Password, enter the
user name and password details. Also set the session estab-
lishment condition as one of the following:
Continuous
Connect on demand. Enter the minutes after which the
session must be disconnected, if no activity takes place.
Manual. Enter the minutes after which the session must
be disconnected, if no activity takes place.
In most cases, you will not need to congure your device with these addresses
because your ISP is likely to use an Internet access type which automatically assigns
addresses to your device. For more information, see TypesofInternetAccess.
Types of Internet Access
The types of Internet access available are as follows:
PPP Internet access your device uses a Point to Point Protocol (PPP) to
carry data between your ISP and your computer. To use PPP Internet access,
you must enter a PPP login username and password the rst time to log on.
The IP addresses required to access your ISP’s Internet service are automati-
cally congured.
Your device supports PPPoE (over Ethernet).
PPP Internet access your device uses a Point to Point Protocol (PPP) to
carry data between your ISP and your computer. To use PPP Internet access,
you must enter a PPP login username and password the rst time to log on.
The IP addresses required to access your ISP’s Internet service are automati-
cally congured.
Your device supports PPPoA (over ATM).
Bridged Internet access your device uses a Bridge mode with your PP-
PoE Client Software to carry data between your ISP and your computer. To
use Bridged Internet access with your PPPoE Client Software, you must
enter a PPP login username and password the rst time to log on. The IP
addresses required to access your ISP’s Internet service are automatically
congured.
Your device supports RFC 1483 Bridged Mode).
Conguring your PPPoE DSL connection
If your ISP’s Internet service uses PPPoE you need to set up a PPP login account.
The rst time that you login to the Internet, your ISP will ask you to enter a username
and password so they can check that you are a legitimate, registered Internet service
user. Your device stores these authentication details, so you will not have to enter this
username and password every time you login.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Modecom MC-4220 and is the answer not in the manual?

Modecom MC-4220 Specifications

General IconGeneral
BrandModecom
ModelMC-4220
CategoryNetwork Router
LanguageEnglish