Your ISP may also tell you to set unique path and circuit numbers (called VPI and
VCI) in order to connect your device to the ISP’s Internet service. In most cases, your
device will use default settings, so you may not need to enter these values.
Note
Your ISP will provide you with the login details and VPI/VCI values necessary to
set up a PPP login account.
If your ISP wants you to connect to the Internet using PPP, follow the instructions
below.
1. From the left-hand WANmenu, click on ChannelCong. The following page is
displayed:
2. Enter VCI and VPI setting determined by your ISP.
3. Select the Encapsulation determined by your ISP.
4. From the ChannelMode drop-down list, select PPPoE setting.
5. Enter UserName/Password provided by your ISP. Type them in the relevant
boxes.
6. If you are happy with your settings, click Add
To Next Page
Loading...