3. Plug the Ethernet cable into AP’s LAN port and make sure the IP connection is
valid with Vista.
4. Make sure WCN is enabled. Users may need to enable it at the rst time. They
could open the “Control Panel”, click “Classic View“, open “Administrative Tools”,
double click “Services”, ”, a User Account Control pop up and click “Continue“, edit
properties of “Windows Connect Now”, choose the “Startup type” with “Automatic”
and click “Start”.
5. If the previous steps are done, open Windows Explorer. Go to the Network sec-
tion.
6. Click on “Network discovery and le sharing are turned off. Network computers
and devices are not visible. Click to Change…“
To Next Page
Loading...