Motorola TC55 - Using the Imager; Figure 35: Data Capture with Camera; Figure 36: Data Capture

Figure 35: Data Capture with Camera
4 Move the TC55 until the bar code is centered under the red target.
5 The LED light green, a beep sounds and the TC55 vibrates, by default, to indicate the bar code was decoded
successfully. The captured data appears in the text field.
Using the Imager
To capture bar code data:
Procedure:
1 Ensure that an application is open on the TC55 and a text field is in focus (text cursor in text field).
2 Point the top of the TC55 at a bar code.
Figure 36: Data Capture
48 | DataWedge Configuration
Send Feedback | October 2013 | MN000017A01