SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
TRANSMISSION
Ch 2 page 144 Ch 2 page 145
TRANSMISSION
TRANSMISSION
Ch 2 page 144 Ch 2 page 145
TRANSMISSION
Dismount the axle catcher bow. (white arrow)
Dismount converter prop. shaft. (red arrow)
Front screw: M12x50 ISO4014-10.9 EL
Rear screw: ½” UNF x2” NS 965--8.8
Disassemble the front transmission bracket attachment.
If shim are assembled, use the shims at the same place when as
-
semblying.
Use standard tool as shown on the picture below or similar.
Assembly:
Torque limit 560 Nm
Pipe 30 mm ¾#
Extension L= 4”
Arm with ¾#
Combination
wrench 30 mm
Check around the transmission that all connections to the front
frame equipment not are connected to the transmission.
Assemble the lifting device and start lifting the transmission out of
the frame.
Carefylly !
Be aware that the transmission have to be moved frontwards,
twisted to the right side on front. In this position carefully lift up the
transmission.
Be specially aware of the transmission differential otput flange and
the back side.
Picture show the left side, front diff, output flange.
To Next Page
Loading...