SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
TRANSMISSION
Ch 2 page 158 Ch 2 page 159
TRANSMISSION
TRANSMISSION
Ch 2 page 158 Ch 2 page 159
TRANSMISSION
Figure 151
Figure 154
Figure 153
Figure 152
3.1.5 Countershaft
Remove sealing cover and loosen hex. head screws.
Tilt gearbox housing by 90°
Loosen hex. head screw and pull bearing cover KV/K1, KR/K2 and
K4/K3 from the housing bore.
Mark installation position of the bearing covers!
(S) Striker 504225
(S) Set of threads 504191
3.1.6 Disassemble inductive transmitter (3x)
612 = n – Turbine
608 = n – Central gear train
606 = n – Engine
Tilt gearbox housing by 90°.
Drive countershaft axle off the housing bore or the countershaft
support by means of a striker.
(S) Striker 504225
To Next Page
Loading...