TRANSMISSION
Ch 2 page 238 Ch 2 page 239
TRANSMISSION
SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
TRANSMISSION
Ch 2 page 238 Ch 2 page 239
TRANSMISSION
SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
Figure 408
Figure 411
Figure 410
Figure 409
Mount bearing outer race.
Uniformly press on bearing outer race and determine measure II
from bearing outer race to mounting face.
Measure II e.g.. ........................................ 64,00 mm
Take several measuring points and determine
average value!
(S) Straight edge 504170
(S) Digital-depth gauge 504175
Apply sealing compound (Loctite, type-no. 574) to mounting face.
Install two adjusting screws and position housing cover on gear
-
box housing until contact is obtained, use lifting device.
(S) Adjusting screws 504184
(S) Lifting device 504199
Install bearing outer race.
CALCULATION EXAMPLE “E“:
Measure I e.g. ......................................... 66,36 mm
Measure II e.g. .........................................
− 64,00 mm
Difference ................................................. 2,36 mm
Required bearing pre-load e.g. + 0,04 mm
Gives shim e.g. s = 2,40 mm
Insert shim.
To Next Page
Loading...