5-6 Specifying Destinations
Searching for Server Destinations
You can search for and select destinations from an LDAP (Lightweight Directory Access
Protocol) server and address book destinations. There are two methods for searching
for destinations; “simple search”, which enables you to search by entering part of the
destination, and “advanced search”, which enables you to search by setting detailed
conditions.
Register the LDAP server in advance. For details on the procedure for registering
servers, refer to Chapter 2, “Specifying the Network Settings” in the Administrator’s
Guide.
Simple Searching
Enter part of the name or e-mail address to search for.
Press <Scan> or <Fax>.
1
Press [Search] on the [Send to E-mail] tab of the scanner screen or [Search] on
2
the fax screen.
Enter part of the name or the e-mail address to search for, and press [Execute].
3
Up to 30 characters can be entered.•
For details on entering characters, refer to Chapter 1, “Entering Characters” in the •
Administrator’s Guide.
You can press [Server] on the search screen to change the server to perform searching. •
Normally perform searching using the specified server.
To Next Page
Loading...
Need help?
General
