Press [Resolution].
2
If [Resolution] is not displayed, press the [Advanced] tab and then select [Resolution].
Select the desired resolution, and press [Enter].
3
Specify the destination.
4
For details on the procedure, refer to “• Basic Scanning”. (See page 1-2.)
If you loaded the document in the ADF, this concludes the procedure.•
If you loaded the document on the document glass, load the next document, and press •
[Next Doc]. To finish scanning, press [Complete].
Setting the Scan Format
You can set whether to scan the document in color or monochrome.
Load the document, and press <Scan>.
1
For details on loading documents, refer to Chapter 1, “Loading Documents” in the User’s
Guide.
To Next Page
Loading...
Need help?
General
