Loading a roll media 25
[2]
Place the roll media onto the left media holder. Carefully and gently place it on the holder.
(If torque is enabled)
: When looking from the left side, check that the protrusion on the roller shaft guide plate is fitted into between
two protrusions on the flange end cap.
: When looking from the rear side of the printer, check that the flange end cap is properly placed on the protrusion
on the roller shaft guide plate.
Do not drop or apply excessive impact while placing the media. This will cause damage to the part.
(If torque is disabled)
• Check that the stopper on the shaft is fitted into the slit as shown in the illustration (not on the media holder).
Important!
When you adjust the position of the media holder (left), do not move it more than 450 mm away from the left-hand
end. The printer will not be able to detect media.
To Next Page
Loading...
