85
STEP 19:Press or Exec soft key to start the data
backup. While making a backup copy, the
LCD displays “Uploading...” first and then
“Saving...”.
STEP 20:After the data backup is complete, the display
changes as follows:
The display goes back to the Backup/
Restore screen by Exit soft key.
Note:
Do not change the extension of the backup file.
The setting data of the telephone can only be
backed up as a.tgz file.
Note:
When changing the default file name, press BK
soft key once to delete the default file name and
then enter a new file name by using the digits
keys.
Note:
For details on character entry method, see HOW
TO INPUT CHARACTERS in chapter 4 Basic
Operation.
Note:
A maximum of 20 characters ("0-9", "A-Z", "a-z",
"*", "#", ".", "-" or "_") can be entered as a file
name.
Note:
To delete an entered character, press BK soft
key.
Note:
Be sure not to turn OFF the DT700 Series while
"Saving..." is displayed on the LCD.
Note:
When the data backup ends in failure, "Upload
Failed!" is displayed on the LCD. Check to see
the following and then make a retry.
Check Points Actions
A different file name is
specified between
DT700 Series and FTP/
TFTP server.
Set the same file name
from both DT700 Series
and FTP/TFTP server.
Incorrect IP address of
FTP/TFTP server has
been entered from the
telephone.
Set the proper IP address
of FTP/TFTP server.
The power to FTP/
TFTP server or network
equipment is OFF.
Turn on the power.
LAN cable is
disconnected.
Reconnect the cable
securely.
To Next Page
Loading...
Need help?
General