CHAPTER 3 SYSTEM DATA PROGRAMMING
– 102 –
NWA-008855-001 Rev.1.0
avch3001.fm
DESCRIPTION DATA
Assign the LEN of the Control CS which has a
SYS-ID.
•
(1)
(2)
Y=00
02: Assignment of CS with SYS-ID
000-758: LEN
Set the Control Signal Mode of the Calling Ar-
ea.
•
(1)
(2)
Y=10
00-31: Calling Area No.
02 : Crowded Mode
15 : Normal Mode
NOTE: The Mode is assigned according to the traffic. When the accommodated CS encounters
high traffic in its radio zone, select the mode to 02 Crowded Mode, so that the CS manages
to process the calls, but the PS uses much more battery than Normal Mode.
Specify the width of the Calling Area.
When there are many CSs in the Calling Area
and each CS covers a narrow area, follow the
initial data setting 3.
When a CS covers a wide area, set the data to
1.
•
(1)
(2)
Y=11
00-31: Calling Area No.
1: Wide
3 : Narrow
Specify the Control Channel Slot used for
Handover as 00.
NOTE: This assignment is required only
when BS31 is accommodated.
•
(1)
(2)
Y=19
00: Assignment of Control Channel Slot
00: Control Channel Slot No. 00
Assign the delay correction data for Handover
when the BS31 is used together with the BS21/
BS21A.
NOTE: This assignment is required only
when BS31 is accommodated.
•
(1)
(2)
Y=19
01: Delay Correction
03 : BS31 and BS21/BS21A are used
NONE : Only BS31 is used
After assigning the CS data, Make Idle the CS
by this command.
When the CS data has been assigned by CM14,
the CS automatically becomes Make Busy
state.
•
(1)
(2)
Y=3
000-255: CS No.
0 : Make Busy (Forced)
1: Make Idle
2 : Make Busy after calls finished
E
CMAE
CSH INITIAL
CSH INITIAL
CSH INITIAL
CSH INITIAL
CME5
END
CS DATA PROGRAMMING
To Next Page
Loading...
