NEC NEAX 2000 IPS - Page 116

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 106 –
NWA-008855-001 Rev.1.0
avch3001.fm
DESCRIPTION DATA
Register the MAC Address of the IP-CS.
NOTE: Register the MAC Address printed
on the back side of IP-CS. When this
data is not set, IP-CS does not start
up.
•
(1)
(2)
Y=27
000-255: CS No.
XXXXXXXXXXXX: MAC Address
Specify whether Master IP-CS, Submaster IP-
CS or Slave IP-CS for wireless synchroniza-
tion between IP-CSs.
•
(1)
(2)
Y=28
000-255: CS No.
0 : Master IP-CS
1 : Submaster IP-CS
2 : Slave IP-CS
NONE : Slave IP-CS
Assign the location number for each IP-CS. •
(1)
(2)
Y=29
000-255: CS No.
00-63 : Location No.
NONE : Location No. 00
Assign the Wireless Block Number for each
IP-CS.
NOTE: Set the same wireless block number
for the group of IP-CS whose radio
zone overlaps directly or indirectly
each other.
•
(1)
(2)
Y=30
000-255: CS No.
00-09 : Wireless Block No.
NONE : Wireless Block No. 00
Assign the synchronizing destination SYS-ID
that is given priority.
NOTE: Set CMAE Y=22 when the Master
IP-CS synchronizing with an IP-CS/
legacy CS that has different SYS-ID
from the Master IP-CS including a
cell station locally provided by cus-
tomer.
•
(1)
(2)
Y=22
00-09:Wireless Block No. set by CMAD
Y=30
XXXXXXXXX: Destination SYS-ID for
Clock Synchronization
(9 digits decimal)
C
CMAD
CMAE
D
CS DATA PROGRAMMING