CHAPTER 3 SYSTEM DATA PROGRAMMING
– 109 –
NWA-008855-001 Rev.1.0
avch3001.fm
DESCRIPTION DATA
Specify the minimum value of jitter buffer be-
tween location groups to each location number
assigned by CMAD Y=29.
[Series 3200 R6.2 software required]
NOTE 1: Assign the value which does not ex-
ceed the maximum value of jitter
buffer set by CM67 Y=05.
NOTE 2: This data setting is valid to the
group that is set to “XX” in the first
data.
•
(1)
(2)
Y=04
XX ZZ
XX: 00-63: Location No. of group
ZZ : 00-63: Location No. of group
01-30 : 10 ms.-300 ms.
(10 ms. increments)
NONE : 10 ms.
Specify the maximum value of jitter buffer be-
tween location groups to each location number
assigned by CMAD Y=29.
[Series 3200 R6.2 software required]
NOTE 1: Assign the value which exceeds the
minimum value of jitter buffer set by
CM67 Y=04.
NOTE 2: This data setting is valid to the
group that is set to “XX” in the first
data.
NOTE 3: Assign the value which is multiple of
the payload size assigned by CM67
Y=00 to the location number that is
set to the PN-8IPLA (IP-PAD) card.
If the setting value of the second
data is not multiple of the payload
size, the value that the reminder is
omitted is assigned to the location
number automatically.
•
(1)
(2)
Y=05
XX ZZ
XX: 00-63: Location No. of group
ZZ : 00-63: Location No. of group
01-30 : 10 ms.-300 ms.
(10 ms. increments)
NONE : 300 ms.
F
CM67
G
CS DATA PROGRAMMING
To Next Page
Loading...
