CHAPTER 3 SYSTEM DATA PROGRAMMING
– 112 –
NWA-008855-001 Rev.1.0
avch3001.fm
DESCRIPTION DATA
Specify the limit bandwidth for the traffic be-
tween location groups to each location number
assigned by CMAD Y=29.
•
(1)
(2)
Y=90
XX ZZ
XX: 00-63: Location No. of group
ZZ : 00-63: Location No. of group
00000-65534: 0 Kbps-65534 Kbps
NOTE 1
NONE : 100000 Kbps (100 Mbps)
NOTE 1: Set the bandwidth for voice packets. The available bandwidth minus the bandwidth for
control packets (40 Kbps) is the bandwidth for voice packets.
If the reflection speed of terminals such as button reflection becomes slower by setting the
value above-mentioned, set the bandwidth for voice packets to the value with the band-
width for control packets supposed as more than 40 Kbps.
NOTE 2: Assign the value that exceeds the warning bandwidth set by CM67 Y=92.
Specify the action when the traffic between lo-
cation groups exceeds the limit bandwidth as-
signed by CM67 Y=90.
•
(1)
(2)
Y=91
XX ZZ
XX: 00-63: Location No. of group
ZZ : 00-63: Location No. of group
0 : Restrict the connection between loca-
tion groups
3 : Keep the connection between location
groups
Specify the warning bandwidth for the traffic
between location groups to each location num-
ber assigned by CMAD Y=29.
•
(1)
(2)
Y=92
XX ZZ
XX: 00-63: Location No. of group
ZZ : 00-63: Location No. of group
00000-65534: 0 Kbps-65534 Kbps
NONE : 100000 Kbps (100 Mbps)
NOTE: Assign the value that does not exceed the limit bandwidth set by CM67 Y=90.
I
CM67
J
CS DATA PROGRAMMING
To Next Page
Loading...
