CHAPTER 3 SYSTEM DATA PROGRAMMING
– 137 –
NWA-008855-001 Rev.1.0
avch3001.fm
To display the calling information on PS when a call is terminated from a station, do the following pro-
gramming in addition to the programming on Page 136.
DESCRIPTION DATA
Enter the desired station user’s name to each
station number by CM77 Y=0 or CM77 Y=1.
•
(1)
(2)
Y=0 By Character Code
X-XXXXXXXX: Virtual Station No. as-
signed by CM14
Character Code 20-7F: Maximum 32 digits
See Character Code Table.
Page 141
•
(1)
(2)
Y=1 By Character
X-XXXXXXXX: Virtual Station No. as-
signed by CM14
A-Z, 0-9: Character
Maximum 16 Characters
NOTE: There are two ways to change a name that is currently programmed. (1) Overwriting with
a new name, or (2) inserting a blank space as the first character will cancel the existing
name.
Specify the calling information displayed on
PS when a station calls a PS with consultation
holding the other station/trunk.
[Series 3500 software required]
(1)
(2)
555
0 : Information of holding call
(Station/Trunk information)
1 : Information of calling station
A
CM77
CM08
END
WCS FEATURE PROGRAMMING
To Next Page
Loading...
