CHAPTER 3 SYSTEM DATA PROGRAMMING
– 138 –
NWA-008855-001 Rev.1.0
avch3001.fm
To display the calling information on PS when a call is terminated from a Trunk:
• When a Caller ID signal is sent from a network, do the programming only START to A on Page 136.
• When a Caller ID signal is not sent from a network, and to display the Trunk name on PS when a call
is terminated from a Trunk (individual signal line), do the following programming in addition to the
programming on Page 136.
[Series 3500 software required]
DESCRIPTION DATA
Specify the calling information displayed on
PS when a call is terminated from a individual
signal line trunk.
(1)
(2)
556
0 : Trunk name assigned by CM77 Y=2/
CM77 Y=3
1: Not displayed
Assign a trunk name number to each trunk
route.
•
(1)
(2)
Y=03
00-63: Trunk Route No.
00-14: Trunk Name No. 00-14
15 : Kind of trunk route assigned by
CM35 Y=00 is displayed
16-63: Trunk Name No. 16-63
Enter the desired trunk name to each trunk
route by CM77 Y=2 or CM77 Y=3.
•
(1)
(2)
Y=2 By Character Code
00-14, 16-63: Trunk route name No.
assigned by CM35 Y=03
Character Code 20-7F: Maximum 8 digits
See Character Code Table.
Page 141
•
(1)
(2)
Y=3 By Character
00-14, 16-63: Trunk route name No.
assigned by CM35 Y=03
A-Z, 0-9: Character
Maximum 4 Characters
NOTE 1: The trunk name display is provided on a trunk-route basis. The maximum amount of char-
acters in the trunk name is four. The maximum number of trunk routes assignable is 16.
The MAT or CAT can be used to register or change a trunk name display.
NOTE 2: There are two ways to change a name that is currently programmed. (1) Overwriting with
a new name, or (2) inserting a blank space as the first character will cancel the existing
name.
A
CM08
CM35
CM77
END
WCS FEATURE PROGRAMMING
To Next Page
Loading...
