CHAPTER 3 SYSTEM DATA PROGRAMMING
– 139 –
NWA-008855-001 Rev.1.0
avch3001.fm
To display the calling information on PS when a call is terminated from an Attendant Console:
[Series 3500 software required]
• To display an attendant console name, do the following programming in addition to the programming
on Page 136.
DESCRIPTION DATA
Enter the desired ATTCON user’s name to
each ATTCON number by CM77 Y=A or
CM77 Y=B.
•
(1)
(2)
Y=A By Character Code
0-7: ATTCON No. assigned by CM14/
CM10
Character Code 20-7F: Maximum 32 digits
See Character Code Table.
Page 141
•
(1)
(2)
Y=B By Character
0-7: ATTCON No. assigned by CM14/
CM10
A-Z, 0-9: Character
Maximum 16 Characters
NOTE: There are two ways to change a name that is currently programmed. (1) Overwriting with
a new name, or (2) inserting a blank space as the first character will cancel the existing
name.
Specify the calling information displayed on
PS when an Attendant Console calls a PS with
consultation holding the other station/trunk.
(1)
(2)
554
0 : Information of holding call
(Station/Trunk information)
1 : Information of Attendant Console
A
CM77
CM08
END
WCS FEATURE PROGRAMMING
To Next Page
Loading...
