PS Location Indication
Page 30 ND-91638-007(E)
Issue 6
6. CS Name can be assigned for CS Number 000 - 127 by CM77 Y=8 (Assigned by Character Code) or Y=9
(Assigned by Character). Max. 16 characters can be assigned as the CS name.
7. This feature has priority over Calling Name Display - PS feature. When both feature are assigned, the CS
name is displayed on the LCD of the D
term
or Attendant Console (the PS name is not displayed).
8. When a D
term
user makes/receives a call to/from a roaming PS, the CS name is not displayed on the LCD
of the D
term
.
9. This feature is not available for data communications by PS.
10. When a PS in conversation with a D
term
moves by handover, the CS name displayed will be changed to the
CS name of the CS after handover.
11. When a PS user makes a call to a D
term
via CCIS, a CS name is not displayed on the LCD of the D
term
.
12. When a D
term
user receives a call from a PS, a CS name is displayed (flashing) on the LCD of the D
term
.
When the D
term
user answers the call, the name is displayed for 6 seconds (no flashing) then changes to the
display of date/time.
13. When a PS user makes a call to station-A, which sets Call Forwarding(-All Calls/ -Busy/ -No Answer) to
station-B (D
term
), the LCD Display of the D
term
(station-B) will be as follows.
1) Name of the called station-A is displayed. (Refer to 14-3.)
2) When station-A is a PS, CS name of the called PS is not displayed. (Refer to 14-2.)
14. Examples of the LCD Display are described below.
14-1-1) When a D
term
user receives a call from PS 200 that is connected to a CS named “Conf. Room #200”,
the called D
term
displays as follow:
←PS number
←CS Name (1-16 characters)
Note 1: When a PS uses Multi-Line Operation and the PS user makes a call using L1(My Line: #200),
the display on the LCD of the D
term
will be same as above.
Note 2: When a PS uses Multi-Line Operation and the PS user makes a call using L2(Sub Line: #200),
the display on the LCD of the D
term
will be same as above.
14-1-2) When a D
term
user makes a call to PS 200 that is connected to CS named “Conf. Room #200”, the call-
ing D
term
displays as follows:
←PS number
←CS Name (1-16 characters)
Note 1: The Display on the LCD is same as 14-1-1, but the CS Name is displayed after the called PS
rings.
Note 2: When the call reaches to L2 (Sub Line: #200) of the PS, the CS Name is displayed after the
PS user answers the call.
Note 3: When the call reaches to L2(Sub Line: #200) of the PS that the PS name is assigned, the PS
name is displayed at the time the D
term
makes a call and it is changed to the CS name at the
time the PS user answers the call.
200
Conf. Room #200
200
Conf. Room #200
To Next Page
Loading...
