NEC NEAX 2000 IPS - Page 29

CHAPTER 1 GENERAL INFORMATION
– 19 –
NWA-008855-001 Rev.1.0
avch1001.fm
WCS Card Name and Function
CARD
NAME
FUNCTIONAL
NAME
FUNCTION
PN-4COTE
[For Austra-
lia]
COT 4-line Central Office Trunk Card (Loop Start Trunk)
Provides a detector for line fault conditions.
Used for WCS Adjunct Type (Analog Interface).
PN-4COTF
[For New
Zealand]
COT 4-line Central Office Trunk Card (Loop Start Trunk/Ground Start
Trunk)
Provides loop holding, pulse sender, and detector for ground sig-
nals.
Used for WCS Adjunct Type (Analog Interface).
PN-6COTJ
[For Austra-
lia]
COT 6-line Central Office Trunk Card (Loop Start Trunk)
Provides a detector for line fault conditions.
Used for WCS Adjunct Type (Analog Interface).
PN-8COTT
[For Austra-
lia]
COT 8-line Central Office Trunk Card (Loop Start Trunk)
Provides a detector for line fault conditions.
Used for WCS Adjunct Type (Analog Interface).
PN-2CSIA-A CSI 2-line Cell Station Interface Card
Used to interface with the CS, based on ISDN S-interface.
Maximum two CSs can be connected per CSI card.
Occupies 8 time slots per one card.
PN-2CSIH CSI 2-line Cell Station Interface Card
Used to interface with the CS, based on ISDN U-interface.
Maximum two CSs can be connected per CSI card.
Occupies 8 time slots per one card.
PN-4CSIA CSI 4-line Cell Station Interface Card
Used to interface with the CS, based on ISDN U-interface.
Maximum four CSs can be connected per CSI card.
Occupies 16 time slots per one card.
PN-4DATC DAT 4-line Digital Announcement Trunk Card
This card is used for Announcement Service on WCS.
Recording duration: Maximum 120 seconds
Continued on next page
CARD NAME AND FUNCTION