NEC Univerge SV9300 - Page 62

TERMINAL SETUP
54
When the backup process ends in
failure, “Upload Failed!” is displayed
on the LCD. Check to see the following
points and retry backup.
CHECK POINTS
ACTIONS
Check whether IP
address/address (URI)
of FTP/TFTP/HTTPS
server is correct or not.
Set the proper IP
address/address
(URI) of
FTP/TFTP/HTTPS
server.
Check whether the
power to
FTP/TFTP/HTTPS
server and network
equipment are ON or
not.
Turn on the power.
Check whether the LAN
cable is connected
securely.
Reconnect the cable
securely.
If the retry of uploading fails many
times, the terminal may be in failure.
For details, please contact the system
administrator.
Other than above conditions, if
"Download Failed!" or "Upload Failed!"
is displayed, please contact the system
administrator.
TO RESTORE THE SETTING
DATA OF TERMINAL
1. Press key to display the Menu
Screen.
2. Select “Setting”.
Highlight an item by using , and press
.
3. Select “ Data Backup/Restore”.
Select one of the following operations.
 Highlight an item by using , and
press , or Soft key (OK).
 Press .
4. Select “ Protocol”.
Select one of the following operations.
 Highlight an item by using , and
press , or Soft key (OK).
 Press .
5. Select a Protocol type of the server
which stores the Backup file.
Select one of the following operations.
 Highlight an item by using , and
press or Soft key (OK).
 Press , or , and press
or Soft key (OK).
The display goes back to the
[Backup/Restore] screen.
6. According to the selection in
[Protocol] screen, proceed to the
following steps below.
 When “ FTP” is selected here, go to
7