How to Use the Feeder
Taking a stack of mail:
1. Arrange the mail according to their size (largest and heaviest on the bottom).
2. Fan the envelopes to ensure separation (sometimes envelopes may be stuck together).
3. Bevel the edge of the stack.
4. Place the envelopes on the hopper against the rear wall and covering the optical
(clear) sensor. Be sure that all envelopes in the stack are against the rear wall.
Ensure that all the envelopes are stacked along the rear guide, from largest to smallest.
Nested envelope flaps : insert the flaps into the slot at the rear
guide of the envelope hopper.
Do not try to seal self-adhesive envelopes. Close them before
feeding.
5. Adjust the high stack side guide. To adjust the guide, push gently against the
envelopes, but do not push it tightly against the stack.
108
| Page 108 | mrt-11-2014 04:31 |
3
Running Mail