Filling the Internal Label Dispenser
The Internal Label Dispenser allows you to print postage on precut labels.
You can put up to 50 labels in the Internal Label Dispenser.
When labels are not in use, preferably leave them flat in the catch
tray or hopper label receptacle.
How to Fill the Internal Label Dispenser
To fill the Internal Label Dispenser:
1. Stack the labels and insert them in the dispenser, face to print on the right-hand
side .
If the labels have a peel-off tab, place the tab on the top.
2. Push the block of labels down firmly, until you feel the click.
Use several labels, as using only one label could be not stiff enough
to be put in place without folding.
3
Running Mail
113
| Page 113 | mrt-11-2014 04:31 |
To Next Page
Loading...
Need help?
General
