Running PPI Mail
After completing the initial set up in Steps to Set Up PPI Mail Printing on page 67 , follow
the steps below to run mail.
Steps to Run PPI Mail
From the Print Mode: [PPI] mail home screen:
1. Start a new Operational PPI Report if necessary.
Press Reset/Report to open the Operational PPI Report screen and start a new report.
You can also print the current report before starting the new one.
For details, see Operational PPI Report and Historic Reports on page 183.
2. Select the sealing mode that corresponds to your mail stack: see Checking the
Sealing Mode on page 55 .
3. Depending on the weighing mode selected, run mail according to one of the sections
below:
Steps to Run Mail in Dynamic Weighing Modes on page 59
Running Mail in Standard Weighing Mode on page 60
Running Mail in Manual Weighing Mode on page 64
When sealer is activated, collect the mail piece stack in the catch
tray and put stack aside to let envelopes dry.
3
Running Mail
71
| Page 71 | mrt-11-2014 04:31 |
To Next Page
Loading...
Need help?
General
