Standard Setup3.2
Recommended Mail Processing Steps
This section recommends a standard list of steps to help you process your mail efficiently.
As mail requirements differ from day to day, some of the settings may not be necessary,
or the order may vary. The order given below is recommended.
Preparing Mail and Mailing System for Operation
Mail preparation involves:
•
Sorting mail by type , to make processing faster (Sorting Mail on page 41 )
•
Logging into the system , to begin setting up your Task (Turning on the System
and Starting a Work Session on page 42 )
•
Checking other system settings : such as active Accounts, Ink level, available
Postage Credit, etc. (Frequently Asked Questions on page 43 ).
Setting Postage and Date of Mailing
A first step is mandatory:
•
It is required that you select the correct Print Mode that corresponds to the current
batch of mail to be processed (Selecting the Print Mode on page 80)
You can then make additional selections depending on required tasks:
•
Select a rate or directly key in a postage value
•
Select a weighing mode (if necessary) or manually enter the postage value from
[Manual amount entry]
•
Advance the Date Setting , if mail will not be deposited at the Post Office on the
day of printing.
You can customize the default values and modes.
To set the default values as supervisor, see Configuring the System
on page 215.
38
| Page 38 | mrt-11-2014 04:31 |
3
Running Mail
To Next Page
Loading...
Need help?
General
