Netafim NMC PRO CLIMATE - Page 83

NMC-PRO
USER GUIDE
Doc. Name: NMC-PRO ׀ User Guide Ver 3.05.03 Revision: 2.2 Page: 83
Crop Management Technologies
# Parameter Explanation Unit/Range Default
8. Dead band ON
The controller starts the CO
2
process when
it is below the desired concentration
minus the Dead band ON.
ppm 100
9.
Radiation
influence
Four point table that describes the
influence of the radiation level on the
desired CO
2
in the greenhouse (Increases
the desired CO
2
concentration)
*See additional explanation below
10. Vent Influence
Four point table that describes the
influence of the vent position on the
desired CO
2
in the greenhouse (Decreases
the desired CO
2
concentration)
NOTE: The system considers the maximum
opened vents in the Zone
*See additional explanation below
Radiation Influence Example:
To optimize the photosynthesis process,
increase the CO
2
concentration during
high solar radiation.
NOTE: The target CO
2
concentration
increases/decreases according to the table
values.
Rad Influence the desired CO
2
Concentration
Radiation
CO
2
Influence
1100
800
650
0
200
150
100
0