4. Use the cam handle to slide the power supply out of the system.
Attention: When removing a power supply, always use two hands to support its weight.
As you remove the power supply, a flap swings into place to block the empty bay, helping to
maintain air flow and cooling.
After you finish
Go to
Install new power supply
on page 41.
Install new power supply
You install a new power supply to replace the failed one. When you install a power supply (referred
to in SANtricity System Manager as a
power-fan canister
), you slide the part into the shelf, close the
cam handle, reconnect the power cord, and reapply power.
Before you begin
• You have a replacement power supply that is supported for your controller shelf or drive shelf
model.
• You have unpacked the replacement power supply.
Steps
1. Make sure that the on/off switch of the new power supply is in the Off position.
2. Using both hands, support and align the edges of the power supply with the opening in the system
chassis, and then gently push the power supply into the chassis using the cam handle.
The power supplies are keyed and can only be installed one way.
Attention: Do not use excessive force when sliding the power supply into the system; you can
damage the connector.
3. Close the cam handle so that the latch clicks into the locked position and the power supply is fully
seated.
4. Reconnect the power supply cabling:
a. Reconnect the power cord to the power supply and the power source.
b. Secure the power cord to the power supply using the power cord retainer.
5. Turn on the power to the new power-fan canister.
After you finish
Go to
Complete power supply replacement
on page 41.
Complete power supply replacement
You complete the power supply replacement by confirming that the new power supply (referred to in
SANtricity System Manager as a
power-fan canister
) is working correctly. Then, you can gather
support data and resume normal operations.
Steps
1. On the new power supply, check that the green Power LED is on and the amber Attention LED is
OFF.
Canisters |
41
To Next Page
Loading...
Need help?
General
