7. Reattach the left cable chain:
a. Locate the horizontal and vertical connectors on the cable chain and their corresponding
horizontal and vertical guide rails inside the enclosure.
b. Align both cable chain connectors with their corresponding guide rails.
c. Slide the cable chain's horizontal connector into the horizontal guide rail and push it in as far
as it will go.
Attention: Risk of equipment malfunction — Make sure to slide the connector within the
guide rail. If the connector rests on the top of the guide rail, problems might occur when the
system runs.
d. Slide the vertical connector on the left cable chain into the vertical guide rail.
e. After you reconnect both ends of the cable chain, carefully pull on the cable chain to verify
that both connectors are latched.
Attention: Risk of equipment malfunction — If the connectors are not latched, the cable
chain might come loose during drawer operation.
8.
Reinstall the left fan canister. If the drive shelf is receiving power, confirm that the amber LED on
the back of the fan is now off and that air is now coming out of the back.
The LED could remain on for as long as a minute after you reinstall the fan while both fans settle
into the correct speed.
After you finish
Go to
Complete drive drawer replacement
on page 77.
Complete drive drawer replacement (60-drive)
You complete the drive drawer replacement by reinserting the drives and replacing the front bezel in
the correct order.
Before you begin
• You know where to install each drive.
• You have already replaced the drive drawer.
• The new drawer cables have been installed.
About this task
Attention: Possible loss of data access – You must install each drive in its original location in the
drive drawer.
Steps
1. Reinstall the drives in the drive drawer:
a. Unlatch the drive drawer by pulling out on both levers at the front of the drawer.
b. Using the extended levers, carefully pull the drive drawer out until it stops. Do not completely
remove the drive drawer from the drive shelf.
c. Determine which drive to install in each slot by using the notes you made when removing the
drives.
Drives |
77
To Next Page
Loading...
Need help?
General
