NETGEAR GS728TS User Manual

132
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
Note: If no MST instances have been configured on the switch, the page
displays a “No MSTs Available” message and does not display any
fields.
To configure MST port settings:
1. To configure MST settings for a physical port, click the unit ID of the stack member with
the ports to configure.
2. To configure MST settings for a Link Aggregation Group (LAG), click LAGS.
3. To configure MST settings for both physical ports and LAGs, click ALL.
4. Select the check box next to the port or LAG to configure. You can select multiple ports and
LAGs to apply the same setting to the selected interfaces. Select the check box in the
heading row to apply the same settings to all interfaces.
5. Configure the MST values for the selected port(s) or LAG(s):
• Port Priority. The priority for a particular port within the selected MST instance. The
port priority is set in multiples of 16. If you specify a value that is not a multiple of 16,
the priority is set to the priority is automatically set to the next lowest priority that is a
multiple of 16. For example, if you set a value between 0 and 15, the priority is set to

NETGEAR GS728TS Specifications

General

Brand	NETGEAR
Model	GS728TS
Category	Switch
Language	English