NETGEAR GS728TS - Port VLAN ID Configuration

113
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
5. Use the Group Operations field to select all the ports and configure them. Possible values
are:
• Untag All: Select all the ports on which all frames transmitted from this VLAN will be
untagged. All the ports will be included in the VLAN.
• Tag All: Select the ports on which all frames transmitted for this VLAN will be tagged.
All the ports will be included in the VLAN.
• Remove All: This selection has the effect of excluding all ports from the selected
VLAN.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
7. If you make any changes to this page, click Apply to send the updated configuration to the
switch. Configuration changes take place immediately.
Port VLAN ID Configuration
The Port PVID Configuration screen lets you assign a port VLAN ID (PVID) to an interface.
PVIDs have the following requirements:
• All ports must have a defined PVID.
• If no other value is specified, the default VLAN PVID is used.
To access the Port PVID Configuration page, click Switching> VLAN > Advanced > Port
PVID Configuration.
To configure PVID information:
1. To configure PVID settings for a physical port, click the unit ID of the stack member with
the ports to configure.
2. To configure PVID settings for a Link Aggregation Group (LAG), click LAGS.