150
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
9. Use the Fast Leave Admin Mode field to select the Fast Leave mode for a particular
interface from the menu. The default is Disable.
10. Click Apply to apply the new settings to the switch. Configuration changes take effect
immediately
11. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
MLD VLAN Configuration
MLD Snooping can be enabled on a per VLAN basis. It is necessary to keep track of the
interfaces that are participating in a VLAN in order to apply or remove configurations.
To access the MLD VLAN Configuration page, click Switchingï€ ï€¾ Multicast  MLD Snooping 
MLD VLAN Configuration.
To configure the MLD VLAN:
1. Set the VLAN IDs for which MLD Snooping is enabled in the VLAN ID field.
2. Enable MLD Snooping for the specified VLAN ID in the Admin Mode field.
3. Enable or disable the MLD Snooping Fast Leave Mode for the specified VLAN ID in the Fast
Leave Admin Mode field.
4. Use the Group Membership Interval field to set the value for group membership interval
of MLD Snooping for the specified VLAN ID. Valid range is (Maximum Response Time + 1)
to 3600.
5. Use the Maximum Response Time field to set the amount of time, in seconds, that a
switch will wait after sending a query on the VLAN because it did not receive a report for
a particular group in that interface. The minimum response time value is 1, and the
maximum value must be at least one second less than the value configured for the
Group Membership Interval.
To Next Page
Loading...
Need help?
General