NETGEAR GS728TS - Access Rule Configuration

217
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
Access Rule Configuration
Use the Access Rule Configuration page to configure the rules about what systems can
access the GS728TS, GS728TPS, GS752TS, or GS752TPS Web interface and what
protocols are allowed.
To access the Access Rule Configuration page, click Security > Access, and then click the
Access Control > Access Rule Configuration link.
Before you create access rules, make sure:
• An access profile exists.
• The access profile is deactivated.
To configure access profile rules:
1. To add an access profile rule, configure the following settings and click Add.
• Rule Type: Specify whether the rule permits or denies access to the GS728TS,
GS728TPS, GS752TS, or GS752TPS management interface.
• Select Permit to allow access to the management interface for traffic that meets
the criteria you configure for the rule. Any traffic that does not meet the rules is
denied.
• Select Deny to prohibit access to the management interface for traffic that meets
the criteria you configure for the rule. Any traffic that does not meet the rules is
allowed access to the switch. Unlike MAC ACLs and IP ACLs, there is no implied
deny
all rule at the end of the rule list.
• Service Type. Select the type of service to allow or prohibit from accessing the switch
management interface:
• SNMP
• HTTP
• HTTPS