213
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
After the session is inactive for the configured amount of time, the administrator is
automatically logged out and must re-enter the password to access the management
interface. A value of zero corresponds to an infinite timeout. The default value is 5
minutes. The currently configured value is shown when the Web page is displayed.
6. In the HTTPS Session Hard Timeout field, specify the number of hours an HTTPS session
can remain active, regardless of session activity. The value must be in the range of (1–168)
hours. The default value is 24 hours. The currently configured value is shown when the Web
page is displayed.
7. In the Maximum Number of HTTPS Sessions field, specify the maximum number of
HTTPS sessions that can be open at the same time. The value must be in the range of
(0–2). The default value is 2. The currently configured value is shown when the Web page is
displayed.
8. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
9. If you make changes to the page, click Apply to apply the changes to the system.
Certificate Management
Use this menu to generate or delete certificates.
To display the Certificate Management page, click Security
 Access, and then click the
HTTPS
 Certificate Management link.
1. The Certificate Present field indicates whether an SSL certificate exists on the switch.
A status of Yes means that a certificate is present, while No means that no certificate
exists.
2. To generate a certificate file, select Generate Certificates and click Apply.
The Certificate Generation Status field displays whether SSL certificate generation is in
progress.
3. To delete the certificate file from the system, select Delete Certificates and click Apply.
To Next Page
Loading...
Need help?
General