293
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
4. Click Apply to send the ping. The switch sends the number of pings specified in the Count
field, and the results are displayed below the configurable data in the Ping area.
• If successful, you will see “Reply From IP/Host: icmp_seq = 0. time = xx usec. Tx = x,
Rx = x Min/Max/Avg RTT = x/x/x msec.”
• If a reply to the ping is not received, you will see “Reply From IP/Host: Destination
Unreachable. Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec”.
Ping Success
Message
Ping Unsuccessful
Message
Ping IPv6
Use the Ping IPv6 page to send a Ping request to a specified Hostname or IPv6 address. You
can use this to check whether the switch can communicate with a particular IPv6 station.
When you click the Apply button, the switch will send three pings and the results will be
displayed below the configurable data.
To access the Ping IPv6 page, click Maintenance
Troubleshooting Ping IPv6.
To Next Page
Loading...
Need help?
General