Figure 15.5.1 - Connection table Buscoupler
15.6 Data communications
The adaptor has 1 x 10/100 TX PoE and three serial ports (IEC61162-2).
In default ‘VDR mode’ in order to offload its data - it relies on the ethernet connection to the core
module which must be IEC61162-450 compliant.
15.7 Indicators
Led Function
PWR Power supply to DIN Busbar established
Link Connected to Core Module
Data Communications
PoE Power Supply by PoE OK
15.8 Errors
If errors occur within the Buscoupler these will be indicated on the display of the Bridge Display
Unit.
15.9 Configuration
The unit does not require any manual configuration.
15.10 Operating instructions
After commissioning of the VDR system, this unit does not require (crew) operating instructions.
To Next Page
Loading...
