154
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
SNMP SHOW ALL
Use the snmp show all command to output SNMP configuration information.
SNMP
SNMPv1, SNMPv2c, SNMPv3
Command form snmp show all
Example Output all SNMP configuration information:
CONTROLLER>snmp show all
SNMP : Enabled
SNMP notify : on
system notify : on
health notify : on
Community number 0
IP protocol version : ipv4
comString : public
Community Type : ro
oid :
source :
...
Notify Host number 2
host : 192.168.0.3
Notify type : trap
Version Set : v2c
sec name : public
To Next Page
Loading...
