Network Critical SmartNA-X - Page 160

155
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
SNMP AGENT / SET SNMP / SHOW SMNP
Use the snmp agent command to enable and disable the SNMP agent, or to show the agent’s current status. The
agent must be enabled to expose management data and send notifications.
SNMP
SNMPv1, SNMPv2c, SNMPv3
Command form snmp {show | enable | disable} agent
set snmp {
on | off }
show snmp
Examples
• Show status of the SNMP agent:
• Enable the SNMP agent:
show | enable | disable Use show to show the current enabled or disabled state the SNMP agent. Use enable
to enable the SNMP agent. Use
disable to disable the SNMP agent.
{
on | off }Use on to enable SNMP. Use off to disable SNMP.
CONTROLLER>snmp show agent
SNMP : Disabled
CONTROLLER>snmp enable agent
CONTROLLER>snmp show agent
SNMP : Enabled