User name Specify a name for the user. Names consist of 1–32 alphanumeric characters, and must begin with a letter.
You may define local users (for most uses) and remote users (for use with sending SNMPv3 informs). If
th
is is a remote user, you must also specify the corresponding remote engine ID.
Engine If setting up a remote user, you must specify the engine ID of th
e remote SNMP agent. Engine IDs
consists of 10–64 hex digits.
Authentication Specify whether authentication is to be used, and if so whether
to use MD5 or SHA authentication.
If authentication is in use, you must also spe
cify a passphrase in the Authentication phrase field that
appears. Authentication phrases must be 8–64 ASCII non-control characters.
For users already set up on the device, either enter a new pa
ssphrase if you wish to make a change or leave
this field blank to keep the existing passphrase.
Privacy Specifies whether encryption is to be used,
and if so whether to use DES or AES.
If encryption is in use, you must also specify a passphrase in the Privacy phrase field that appears. Privacy
phrases mus
t be 8–64 ASCII non-control characters.
For users already set up on the device, either enter a new pa
ssphrase if you wish to make a change or leave
this field blank to keep the existing passphrase.
Community string Specifies a community string for the community. The string must
consist of 1–32 alphanumeric
characters, and must begin with a letter.
IP version Specifies whether this community strin
g allows access via IPv4 or IPv6.
Source Restrict access to specific hosts by specifying the s
ource for SNMP requests here. The following formats
are recognized:
Hostname – myserver.mycompany.com
IPv4 Address – 192.168.50.1
IPv4 Subnet (address/mask) – 192.168.50.1/255.255.255.0
IPv4 Subnet (address/pr
efix length) – 192.168.50.1/24
For IPv6 access, use the equivalent formats.
Security name Specifies the security name to add to a group as part
of the SNMP view-based access control system, like
an SNMPv3 user.
197
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
WEB USER-INTERFACE REFERENCE | SNMP TAB
DRAFT
Table B-6 Options for configuring SNMP Users
Option Description
Table B-7 Options for configuring view-based communities (SNMP v3)
Option Description
Table B-8 Options for configuring view-based groups (SNMP v3)
Option Description
Group name Specifies a name for the SNMP group.
Group names consist of 1–32 alphanumeric ch
aracters, and must begin with a letter.
To Next Page
Loading...
