198
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
WEB USER-INTERFACE REFERENCE | SNMP TAB
DRAFT
Member details Specifies details of the member you are adding to the group. This may be one of:
An existing local SNMP user
A security name assigned to an existing V
ACM-enabled SNMP community
The membership will apply only when the specified security
model is used for a request. The same
member may belong to different groups with different security models.
Security model The security name you specify here may be added to a group as part of the SNMP view-based access
contr
ol system, like an SNMPv3 user.
Name Specifies a name for the view.
View type Indicates whether this view contains the tree belo
w the specified OID or everything else.
OID Specifies the position in the management tree below which this view applies.
Mask May be used to specify that only some of the
subidentifiers in the OID are to be matched.
Group name You must specify the name of an existing group that will receive this access.
Security model Access will only be granted if the securit
y model matches the request.
Security level Access will only be granted if the security of the r
equest meets the minimum requirement specified here.
The order is:
None (lowest)
Auth
Auth+Priv (highest)
Context Specify the context name to use for requests, and whether it works
as a prefix or requires an exact match.
The context string may be up to 32 alphanumeric characters. This setting is optional.
Read view Specify the name of an existing view, or leav
e blank if read access is not required.
Write view Specify the name of an existing view, or leav
e blank if write access is not required.
Notify view Specify the name of an existing view, or leav
e blank if notify access is not required.
Table B-9 Options for configuring view-based view (SNMP v3)
Option Description
Table B-10 Options for configuring view-based access control (SNMP v3)
Option Description
Table B-8 Options for configuring view-based groups (SNMP v3)
Option Description
To Next Page
Loading...
