74
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
CREATE SETTINGS
Use the create settings command to save current settings for ports, port mappings, packet filters and SNMP (not
saved are network settings, firmware or counter states). Use the restore command to restore a profile.
Command form create settings name-string
Example Save current system settings to a configuration called config_tap1:
name-string Specifies a name for the settings. Names can include alphanumeric characters and
the underscore character “_” only. Spaces and punctuation characters can not be
used. name-string is case-sensitive, so config and Config will be saved separately.
CONTROLLER>create settings config_tap1
Settings saved OK
To Next Page
Loading...
