75
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
RESTORE
Use the restore command to restore the default configuration or a user-saved profile. Restoring a profile will
overwrite port settings, filters, port maps and SNMP settings. To see a list of profiles that are available for
restoring, use the restore command without the name-string parameter. Restoring “factory_defaults” will reset the
system to the default configuration.
Command form restore name-string
Example Restore system using saved configuration config_tap1:
name-string Specifies the name of the settings you want to restore. Using restore without the
name-string parameter outputs a list of the available profiles.
CONTROLLER>restore config_tap1
applied settings OK
To Next Page
Loading...
