82
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
SET/SHOW CONTACT
Use the set contact command to configure contact information for the SmartNA-X administrator or designated
contact. Use the show contact command to display the current system contact string.
Command form set contact contact_string
show contact
Example Set the contact string to SmartNA-X Administrator Tel: 555 123 456:
contact_string Specifies the contact name string. The string must start with a letter (A-Z, a-z) and
must contain only alphanumeric characters (A-Z, a-z, 0-9), spaces and underscores
(_). If the string includes a comma and you are using a RADIUS server, the comma
will replaced by an underscore when viewed in server logs. Default: “Network
Critical”.
CONTROLLER>set contact SmartNA-X Administrator Tel: 555 123 456
To Next Page
Loading...
