3.29 EDH0162En1040 – 06/99
MM4005 CM — Change communication mode
Usage IMM PGM MIP
Syntax CM[Mxx][Txx][Axx][Qxx][Bxx][Pxx][Lxx][Sxx][Oxx][Rxx][Xxx] or CM?
Parameters
Description M
— Communication mode.
xx = 1 IEEE-488.
xx ≠ 1 or missing RS-232-C.
T — Terminator character.
xx = 1 CR.
xx = 2 LFCR.
xx = 3 CRLF.
xx ≠ 1, 2, 3 or missing LF
A — IEEE address.
xx 0 to 31
R
— Reserved.
xx = 0
Q
— IEEE-488 SRQ mode.
xx = 1 YES.
xx ≠ 1 or missing NO SRQ
B — Serial transmission speed.
xx 1200, 2400, 4800, 9600, 38400, 57600 or 115200.
xx different or missing 9600
P
— Parity
xx = 1 Odd parity.
xx = 2 Even parity.
xx ≠ 1, 2 or missing NO parity
L — Data length.
xx 7
xx ≠ 7
or missing 8
S
— Stop bit number
xx 2
xx ≠ 2
or missing 1
O
— Communication time out
xx 0.5 to 999 sec.
Defaults xx Missing: CMM0T0B9600P0L8S1O1R0
X — XON/XOFF mode.
Defaults xx = 0 XON/XOFF mode enable.
xx = 1 XON/XOFF mode disable.
Description This command changes the communication mode between the controller
and the PC.
Returns In the case of CM? command, it reports the actual communication parame-
ters of the controller.
Errors A — Unknown message code.
Q — Unauthorized command.
Rel. Commands None.
Example CM | Initialization of all parameters.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
